1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
1 OF 2
DMX 8-WAY SPLITTER
®
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installaon instrucons thoroughly.
WARNING
Safety & Warnings
• Install in accordance with the Naonal Electric Code, and local
regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• DO NOT connect directly to high voltage power. Install with a compable
Class 2 constant voltage LED driver (power supply).
• Only install compable LED drivers and xtures. Contact technical
support or visit the product page for compable products.
• This product is rated for indoor installaon and is not protected against
moisture.
• Proper heat dissipaon will prolong the working lifespan of this product.
Install in a well-venlated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, xture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rang, and type (in-wall rated, wet locaon rated, etc.).
Inadequate wire installaon could overhead wires, and cause a re.
• Do not modify or disassemble this product beyond instrucons or the
warranty will be void.
Quick Specs
Input Signal DMX512
Input / Output Voltage 12-24VDC Constant Voltage
DMX512 Connecon Ports
Input: (1x) Male XLR-3
Output: (8x) Female XLR-3
Ambient Temperature † -4° ~ 104°F (-20° ~ 40°C)
Included Models
DI-1804
† Do not install product in an environment outside the listed ambient
temperature.
Prior to installaon, verify all components are a compable system. Congure and pre-test your LED system prior to permanent installaon to ensure all
components are operang correctly. Install in accordance with the NEC and local regulaons.
Installation
WARNING
Shock Hazard. May result in serious injury or death.
Turn OFF High Voltage AC Power at the main breaker.
ON
OFFOFFOFF
ONON
OFFOFF
ONON
Determine Locaons to Install 4 Main Components.
1) Driver 3) DMX Splier
2) DMX
Controller
4) Fixture(s)
Determine an accessible locaon to install a compable driver between
the main breaker and DMX Splier. Also, determine locaons to install
addional system components such as DMX xtures, controllers, etc.
Aach Lighng Load and Driver. Only use copper wiring.
Reference ‘Wiring Connecons’ located further in guide for
visual. Verify a compable constant voltage driver is installed.
Install Addional Components, Verify Connecons, and Turn
Main Power ON at Breaker.
ON
OFFOFFOFF
ONON
OFFOFF
ONON
If system remains unresponsive or is working improperly, turn OFF
main power at breaker and verify all connecons. Review the ‘Wiring
Connecons’, ‘Troubleshoong’, and DMX installaon guides.
IG061714-1.1
DO NOT CONNECT
TO HIGH VOLTAGE
Comments to this Manuals